Analytica GmbH AnaGate CAN duo User Manual download pdf (Page 15)

Configuration

The inputs will be taken over immediately after clicking the button Save settings

and saved permanently on the AnaGate CAN Gateway . A restart of the device is not

necessary for activation of the settings.

Note

Maybe the ARP cache of the PC has to be deleted to find the device with

the changed IP address.

2.3. CAN settings

On the page CAN Settings the global settings for all existing CAN interfaces are

displayed and can be changed individually.

Figure 2.3. HTTP interface, CAN settings

Baudrate The baud rate can be selected easily via a list box

containing all supported values.

Termination Use the check box to switch on/off the internal

termination resistor.

High Speed Activates/deactivates the Highspeed mode. In this

operating mode all incoming/outgoing CAN telegrams

are not longer confirmed by the opposite LAN side to

accelerate process throughput. Software-Filters are

switched off too in this mode.

Boot with operational mode Initial operating mode of the CAN controller. Default

value is offline.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 33 34

No comments

Analytica GmbH AnaGate CAN duo User Manual Page 15